Common faults and troubleshooting methods of valve electric actuators

Electric actuator, also known as Electric Actuator, electric device, may encounter faults and troubleshooting methods when opening and closing valves in daily life, today I will summarize for you:

一. The motor of the Electric Actuator cannot start Reasons:

1. The power cord is loose;

2. Control line failure;

3. Stroke or torque mechanism failure.

Troubleshooting methods:

1. Check the power cord;

2. Eliminate line faults;

3. Eliminate stroke or torque faults.

二. The rotation direction of the output shaft of the electric actuator does not meet the regulations Reason: The power line is connected in reverse; Elimination method: Replace any two power cords;

III. Electric Actuator Motor overheating Reasons:

1. Continuous working time is too long;

2. The motor and the electric actuator are not matched;

3. Lack of phase. Elimination methods: 1. Stop running to cool the motor; 2. Check the supporting situation;

3. Check the power cord.

四. Reasons for motor shutdown during electric actuator operation:

1. Torque control action;

2. Valve failure.

Elimination method:

1. Increase the setting torque; 2. Check the valve.

五. The motor does not stop or the light does not turn on after the electric actuator is in place Reasons: 1. Failure of stroke or torque mechanism; 2. Improper adjustment of the stroke controller. Elimination method: 1. Check the stroke torque mechanism; 2. Readjust the itinerary mechanism.